TORKO

P0344 Camshaft position sensor A circuit intermittent (bank 1 or single sensor)

What P0344 means

The engine computer has seen the signal from camshaft position sensor A on bank 1 cut out or become erratic for short periods. Each drop-out can cause a stumble, and the engine may stall or be slow to restart.

P0344 is a generic SAE J2012 code: it means the same on every make. The exact cause still depends on the car, so read the freeze-frame data before replacing parts.

At a glance

Severity
High
Typical repair cost
60–500 €
Workshop time
0.5–2.5 h
Repair difficulty
Medium
DIY possible
Yes
Check engine light
Yes
Affects emissions test
Yes

Parts and labour at an independent workshop in Europe. Main dealers charge more; the cause decides the bill, not the code.

Symptoms

Common causes

  1. Loose or corroded connector
  2. Chafed or broken wire making intermittent contact
  3. Failing camshaft position sensor, often when hot
  4. Damaged target wheel or debris on the sensor tip

Can I keep driving with P0344?

Get it checked within a few days. Intermittent drop-outs can cause stalling without warning.

What to check first

  1. Check the connector for loose terminals and oil contamination; clean and reseat it.
  2. Wiggle the harness with the engine idling while watching for drop-outs or stumbling.
  3. Inspect the sensor tip and target wheel.
  4. Replace the sensor if the wiring holds up, especially if the fault appears when the engine is hot.

Related codes

Data: TORKO fault-code catalogue, built on OBDex (CC0-1.0) and reviewed against workshop practice. Informational only — it does not replace a diagnosis by a mechanic.
Updated: