TORKO

P0715 Input/turbine shaft speed sensor A circuit

What P0715 means

The transmission control unit is not getting a valid signal from the input (turbine) shaft speed sensor. Without it the unit cannot calculate slip or time shifts, so it often switches to limp mode.

P0715 is a generic SAE J2012 code: it means the same on every make. The exact cause still depends on the car, so read the freeze-frame data before replacing parts.

At a glance

Severity
Medium
Typical repair cost
120–450 €
Workshop time
1.5–6 h
Repair difficulty
Hard
DIY possible
No
Check engine light
Yes
Affects emissions test
No
Limp mode possible
Yes

Parts and labour at an independent workshop in Europe. Main dealers charge more; the cause decides the bill, not the code.

Symptoms

Common causes

  1. Failed input shaft speed sensor
  2. Damaged wiring or corroded connector
  3. Metal debris on the sensor tip
  4. Internal gearbox harness or control unit fault

Can I keep driving with P0715?

You can drive gently to a workshop, but have it checked within one to two weeks. Avoid motorway speeds if the gearbox is stuck in one gear.

What to check first

  1. Check the transmission fluid level and condition
  2. Inspect the sensor connector and wiring
  3. Measure the sensor resistance or signal
  4. Replace the sensor or internal harness

Related codes

Data: TORKO fault-code catalogue, built on OBDex (CC0-1.0) and reviewed against workshop practice. Informational only — it does not replace a diagnosis by a mechanic.
Updated: