TORKO

P2008 Intake manifold runner control circuit/open (bank 1)

What P2008 means

The engine control unit has found an open or faulty electrical circuit to the intake manifold runner control actuator or solenoid. The runner flaps cannot be operated, which can reduce power in part of the rev range.

P2008 is a generic SAE J2012 code: it means the same on every make. The exact cause still depends on the car, so read the freeze-frame data before replacing parts.

At a glance

Severity
Medium
Typical repair cost
30–250 €
Workshop time
0.3–1.5 h
Repair difficulty
Easy
DIY possible
Yes
Check engine light
Yes
Affects emissions test
Yes

Parts and labour at an independent workshop in Europe. Main dealers charge more; the cause decides the bill, not the code.

Symptoms

Common causes

  1. Failed runner control actuator or solenoid
  2. Loose or corroded connector
  3. Broken wire in the control circuit
  4. Blown fuse

Can I keep driving with P2008?

You can keep driving, but have it checked within one to two weeks.

What to check first

  1. Inspect the actuator connector and wiring
  2. Check supply voltage and control signal at the actuator
  3. Measure actuator or solenoid resistance
  4. Repair wiring or replace the actuator

Related codes

Data: TORKO fault-code catalogue, built on OBDex (CC0-1.0) and reviewed against workshop practice. Informational only — it does not replace a diagnosis by a mechanic.
Updated: