Failed throttle position sensor (usually inside the throttle body); Open circuit in the 5 V reference wire; Signal wire shorted to ground; Unplugged or corroded connector.

How much does it cost to fix P0222?

Usually 60–400 € at an independent workshop in Europe, depending on which part is at fault.

P0222 Throttle/pedal position sensor B circuit low

What P0222 means

The voltage from throttle position sensor B is lower than the engine computer considers possible. With one of its two throttle sensors out of range, the computer usually switches to limp mode.

P0222 is a generic SAE J2012 code: it means the same on every make. The exact cause still depends on the car, so read the freeze-frame data before replacing parts.

At a glance

Severity: High
Typical repair cost: 60–400 €
Workshop time: 0.3–2 h
Repair difficulty: Medium
DIY possible: Yes
Check engine light: Yes
Affects emissions test: Yes
Limp mode possible: Yes

Parts and labour at an independent workshop in Europe. Main dealers charge more; the cause decides the bill, not the code.

Symptoms

Check engine light on
Limp mode with reduced throttle response
Hesitation or surging
Idle too high or too low

Common causes

Failed throttle position sensor (usually inside the throttle body)
Open circuit in the 5 V reference wire
Signal wire shorted to ground
Unplugged or corroded connector

Can I keep driving with P0222?

Get it checked within a few days. Limp mode leaves very little power, which is risky on fast roads.

What to check first

Check that the throttle body connector is fully plugged in and clean.
Measure the 5 V reference and ground at the connector with the key on.
Check the sensor B signal wire for a short to ground.
Replace the throttle body if wiring is good and run the throttle adaptation.

Related codes

Data: TORKO fault-code catalogue, built on OBDex (CC0-1.0) and reviewed against workshop practice. Informational only — it does not replace a diagnosis by a mechanic.
Updated: 2026-10-24